CAN-Do! NET Controller
A Ready to use AMSAT-CAN Multiple Module Controller
Welcome to the CDNC Web
CAN-Do! Net Controller (CDNC) is a Windows® -based Application written in C# which provides full control over any number of Widget-controlled Modules on the CAN bus while running at full satellite speeds.
Alternatively CDNC can be used to monitor and log traffic on a CAN Bus where it is not the controller and it may also be used as an off-line viewer of traffic which had been earlier captured by CDNC and saved to a file.
Whether looking at traffic from a saved session or traffic just captured live, the full multi-perspective viewing capability of CDNC is always available.
CDNC is built to use either the Peak Systems PCAN USB — PC to CAN interface and its associated PCAN driver for Windows® or the Lawicel CAN232 device.
CDNC runs on Windows XP and Windows 2000.
CDNC is distributed as a zipped self-extracting Windows®-based Installer application.
Information at this site will help you download CDNC, install it and then guide you through an introduction to CDNC so you may start using it immediately.
CAN-Do! NET Controller Website Copyright © 2007, by Stephen M Moraco, KC0FTQ
E-mail: kc0ftq at AMSAT dot org
Microsoft, and Windows are either registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other countries.
Visit our CAN-Do! Project website at http://can-do.moraco.info
Site updated: 4/24/2007 2:50 AM